What should the neighborhood expect during construction?
New mains are typically installed using an open-cut construction method by excavating a trench in a section of roadway. Work will be done on weekdays, during the day. Each day, open trenches will be backfilled and covered with temporary asphalt to provide a drivable surface.
There may be temporary lane closures and/or parking restrictions. Where lane closures are required, the contractor will have signs and flaggers to guide traffic safely through the work zone. The contractor will ensure that residents have access into and out of their driveways.
What part of the water pipe will be replaced?
New water mains will be installed within the paved portion of the roadways and approximately 136 water service lines will be replaced from the new water mains to the water meters. No portion of the water service line on private property will be replaced.
What part of the storm system will be improved?
New storm drain pipe, catch basins, and manholes will be installed within the paved portions of the roadways. Three private property drainage ditches will also be improved.
Why is the sewer main not being replaced as part of this project?
When needed, the City of Renton Wastewater Utility anticipates sliplining the sewer main for trenchless rehabilitation. With sliplining, a new smaller pipe is pulled into the old pipe to repair leaks and restore structural stability to an existing pipeline. The new water and storm mains are to be upsized throughout the neighborhood so sliplining was not recommended.
Will my water meter box be moved?
It is anticipated that the water meters will be moved to the right-of-way and behind sidewalks if there are no adjacent obstructions or hillside. When possible, the water meter box will be placed outside of the sidewalk to reduce tripping hazards. New meter box covers in pedestrian paths of travel will be non-slip in compliance with ADA and City requirements.
What will happen to the water pressure at my house?
The homes in this neighborhood are in a high-pressure zone. High water pressure can cause problems such as noisy pipes, water hammer, damaged water heaters, leaking pipes and faucets, and added stress on your appliances and fixtures.
To help reduce the risk of property damage due to high water pressure, the contractor will be installing new individual pressure reducing valves (PRVs) for each property as part of this project. A PRV provides protection to household plumbing by limiting pressures to a maximum of 80 psi so that pressures are within the Plumbing Code. The City of Renton will pay for the PRV and install it for free. The homeowner will become responsible for maintaining the PRV after one (1) year. The PRV is typically very low maintenance.
The PRV will be installed in a meter box located downstream of the water meter.